16
INSTALLING – Log Grate
ATTACHING LOG GRATE TO
FIREPLACE BASE
1.
Position log grate into fireplace and mark screw locations
on each side of mounting bracket.
2.
Remove grate assembly, drill 2 holes at the marked
locations.
3.
Attach grate assembly to fireplace base. (Screws not
provided.)
4.
Connect to gas supply.
INSTALLATION OF LOGF24
LOGSET
1.
Place main log on locating pins on burner grate bottom.
2.
Place crossover log on locating pins on top of rear main
log.
3.
Position front log flat surface up to main log.
WARNING
You must secure this heater to fireplace base, or heater
will move when you adjust controls. Moving heater
may cause a gas leak and may result in property dam-
age or personal injury.
WARNING
Failure to position the parts in accordance with the
diagrams or failure to use only parts specifically
approved with this heater may result in property
damage or personal injury.
WARNING
The positioning of the logs is critical for the safe and clean operation of this heater. Sooting and other problems can
occur if the logs are not properly and firmly positioned in the heater. Never add additional logs or embellishments such
as pine cones,vermiculite, volcanic rock or rock wool to the heater.
FIGURE 12 – Log Placement
➃
➂
➁
➀
Kingsman Replacement Log Listing
Reference
Part
Number
Number
Description
1
24F-A
Front Main Log A, LOGF24
2
24F-B
Rear Main Log B, LOGF24
3
24F-C
Front Log C, LOGF24
4
24F-D
Crossover Log D, LOGF24
36
