17
Fan Kit Installation
Automatic On/Off Thermostat Controlled
Fan Kit (Part # Z36FK)
1. Open the lower front access cover.
2. The sensor (thermo-disc) needs to be secured under the firebox, the
sensor needs to be in contact with fire box bottom.
3. The two (2) #8x1/2 screws are factory installed in the back of the
fireplace. Mount the fan using the keyhole slots in the fan body.
4. Install a junction box (type to except three prong plug) on the inside
wall of the access area opposite the fan. Large holes are provided to
allow wiring to enter the access area on the left of the unit. Connect
the power, sensor and variable speed wall switch as shown in the
wiring diagram.
5. Close lower access cover.
6. Turn the wall switch on (clockwise). Turn the fireplace on. Once the
sensor unit reaches operating temperature in approximately 10 to 15
minutes the fan will turn on. The fan can be switched off, if desired,
by turning the wall switch fully counter-clockwise.
7. To set the minimum fan speed if desired. Remove the variable speed
switch from the wall mount. Turn the variable speed wall controller
to its minimum setting (fully clockwise). Use the set screw on the
side of the variable speed controller to increase or decrease the min-
imum fan speed. (It may be desirable to lower minimum fan speed
to decrease the sound level created by the fan.) Reinstall switch into
wall mount and cover with face plate.
Electrical Services
All optional fan kits are equipped with a 120V, 60Hz blower.
Note: All electric connections are to be made in accordance with CSA
Standard C22.1 - Canadian Electrical Code part I or with the National
Electrical Code, ANSI/NFPA 70 (latest addition) and/or in accordance
with local codes.
WARNING: Electrical Grounding Instructions. This appliance is
equipped with a three-pronged (grounding) plug for your protec-
tion against shock hazard and should be plugged directly into a
properly grounded three-prong receptacle. Do not cut or remove
the grounding prong from this plug.
Caution: Label all wires prior to disconnection when servicing controls.
Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing.
Fan Mounting Instructions:
1. Install thermodisc provided with fan kit. Screws and washer
spacers are factory installed in bottom of firebox. Washer spacers
are to be placed between firebox and thermodisc.
2. (NEW STYLE MOUNTING SYSTEM) The bottom of the unit has
2 tabs prepunched (bent upwards) for the rubber grommets in fan
bracket. Place fan bracket over tabs. This will secure the fan.
3. Junction box should be mounted to opposite side and wired to
variable speed control and 120 V power.
4. Plug fan into junction box and
attach the 2 leads exiting the
fan housing into the thermodisc.
TOP VIEW
PARTS LIST:
1 ea. fan c/w 4 ft. cord, 2-14” leads
(female ends)
2 ea. #8 x 1/2” screws
1 ea. variable speed control (wall
mount type)
1 ea. thermodisc
Caution:
Should this fan require servicing, the power supply must be disconnected.
