14
NOTE:
With a properly burning flame there
will still be a certain level of sooting. It may be
necessary to clean the glass up to 3 times
during a cold season. The amount of cleaning
required depends on the amount that the fire
place is used.
15. MAINTENANCE
CAUTION:
Label all wires prior to
disconnection when servicing controls. Wiring
errors can cause improper and dangerous
operation. Verify proper operation after
servicing.
WARNING:
INSURE THAT POWER IS
TURNED OFF TO THE FIREPLACE
BEFORE SERVICING.
(a) Blower
This motor has been factory oiled and under
normal operating conditions should not require
oiling.
Replacement of Blower
Remove glass (two screws behind upper grill), and
remove logs. Blower access panel is visible after
rear log is removed. Remove the screws (five on
top, one on each side) and lift from tabs, blower is
then assessable for servicing. Before re-installing
blower access panel, apply a bead of sealant
Millpac to the bottom edge of panel, (this is to
assure blower does not interfere with combustion).
and than secure with screws.
(b) Burner/Pilot
The burner should be periodically cleaned by
removing any ember material and wiping off and
vacuuming the burner pan. At this time it is also
recommended to check the burner for any signs of
corrosion which might impair its operation and
replace it if necessary.
The pilot should also be checked for signs of
proper operation and flame.
If replacement of
pilot, generator, thermocouple is necessary replace
from top and bottom of firebox bottom.
(Reference lower diagram Page 18)
(c) Logs
CAUTION: The logs can stay hot for several
hours after the fireplace is shut off. Serious
burns could result. It is recommended that the
fireplace be turned off for several hours before
cleaning is attempted.
DO NOT
wash the logs if they have any
accumulation of soot on them. Washing the logs in
any sort of solution will just cause the soot to
become imbedded in the logs surface.
The best way to clean the logs is to blow off the
soot using compressed air at high velocity. It is
also effective to use a clean soft brush in the area
of soot accumulation. Vacuuming the log with a
soft brush will also work but do not forget to
carefully wash the brush before using it on
anything else. If at all possible clean the logs
outside the home away from areas you do not wish
the soot to mark.
(d) Firebox and Heat Exchanger
To clean the firebox and heat exchanger use a
vacuum. For the firebox it is recommended to use
a soft brush on the end of the vacuum as not to
damage any painted surfaces. The heat exchanger
may be more difficult to clean but can still be
cleaned with the combination of a small brush and
the vacuum.
(e) Glass
It will be necessary to clean the glass periodically.
During start-up it is normal for condensation to
form on the glass and cause dirt, soot, lint etc., to
adhere to the inner surface of the glass. There also
will be a film deposited on the glass during the
initial use of the fireplace due to initial curing of
the paint. It is recommended that the glass be
cleaned with a non-abrasive household cleaner and
warm water.
