Kingsman VFI25, Руководство по установке

Страница: 10 / 30

10
8. INSTALLATION
NOTE: INSTALLATION AND REPAIR SHOULD BE
PERFORMED BY A QUALIFIED SERVICE PERSON.
THE APPLIANCE SHOULD BE INSPECTED
BEFORE USE AND AT LEAST ANNUALLY BY A
PROFESSIONAL SERVICE PERSON. MORE
FREQUENT CLEANING MA Y BE REQUIRED DUE
TO EXCESSIVE LINT FROM CARPETING, ETC. IT IS
IMPERATIVE THAT THE CONTROL COMPARTMENT,
BURNING AND CIRCULATING AIR PASSAGEWAYS
OF THE APPLIANCE BE KEPT CLEAN.
Install the fireplace insert in the following order:
1. Make sure that the insert will fit into the fire place.
Most Zero Clearance wood fireplaces will need to
be modified. The refractory can be removed if
necessary and the front of the appliance can be
altered to allow the insert to fit into the cavity. Holes
will have to be made in the firebox for the entry of
gas and electrical but the chamber must not be
altered beyond this.
2. Clean and inspect chimney.
3. Plan layout of gas line.
4. Plan layout of electrical.
5. Install the chimney liner as instructed in SECTION 9.
6. Clean out and vacuum the solid fuel fireplace.
Make
sure that the fireplace is completely cool and
has not been used for a few days.
7. Make sure that the solid fuel fireplace base is level
and if not make any necessary adjustments.
8. Slide unit into place attaching draft hood and or
chimney liner as required.
9. Hook up gas line.
10. Hook up electrical.
11. Remove glass by removing two screws behind
upper grill and lifting door off bottom door retainer
(glass is very fragile).
12.
Log Installation:
- Remove logs from carton (4) and inspect.
- Install as per Log Placement set up.
- Purge lines and test pilot operation.
13.
Ember Kit Instructions:
Spread supplied rock evenly on the bottom of
the fireplace around the log set (DO NOT
PLACE ROCK ON BURNERS), next tear ember
wool into small thin pieces and place evenly
over front burner .
14. Re-install the glass door.
15. Check for correct operation
(See SECTION 10)
16. Install Surround and Grills as per instructions.
17. Gas fired appliances may be used only for
supplemental heat and/or decorative purposes
and under no circumstances shall they provide
a primary heat source..
NOTE: DO NOT BLOCK THE SIDES OR
TOP OF THE APPLIANCE AS THIS WILL AFFECT
THE PROPER AND SAFE
OPERATION OF THE UNIT.