Door and Glass Information MCVP42
Glass Cleaning
It will be necessary to clean the glass periodically. During startup, condensation, which is normal, forms on the inside of the glass, and
causes dust, lint etc. to cling to the glass surface.
Also, initial paint curing can deposit a slight film on the glass. It is therefore recommended that initially the glass be cleaned two or three
times with a fireplace glass cleaner. After that, the glass should be cleaned two or three times a season depending on the
circumstances.
Glass Replacement
MCVP42N, MCVP42NE, MCVP42LP, MCVP42LPE
must use tempered glass. Must be 5mm thick.
Only Robax ceramic or coated Neoceram glass may be used for replacement for Models
MCVP42NH, MCVP42NHE, MCVP42LPH,
and MCVP42LPHE
. Glass must be minimum 5mm thick.
To replace glass, clean all materials from the door frame. Scrape off old silicone all the way down to the metal. Using high-temp silicone
[rated up to 500°F (260°C)] apply a continuous bead of approximately 1/
8”-3/16” to all four [4] sides of the frame. With the frame resting
on a flat surface, insert the new glass with a new gasket. Gently press the glass into the silicone. Be careful not to use excessive force
on the glass. Let the silicone dry for approximately 15-20minutes.
Use caution when removing broken glass. Wear gloves.
Removal of Large Glass Doors
1. Remove the door by unlatching the 2 top latches. Simply place 2 fingers in the grooves, and pull and lift upward slightly.
2. Once the top of the door is unlatched, pull it outward and lower it to unlatch the bottom.
3. To re-install, place the Bottom Door Ledge into the 2 Lower Latch assemblies first. Then swing the door closed to seal it against
the firebox cavity. Re-latch the Upper Latch assembly to secure the door to the appliance.
Spring Replacement
*Over time, the door latch spring (Part
# 33IDV-123
) may need
to be replaced if tension is lost.
1. To replace latch spring, remove the 2 hex screws (located in
the firebox) that secure the latch assembly in place.
2. Once the screws are removed the latches will slide out of
place.
3. Remove the locknut from the latch assembly and replace the
spring. Re-tighten the locknut until 2 thread turns are beyond
the locknut. This is critical for proper tension. Replace latch
assembly.
Removal of the Small Glass Door
1. Unlatch the two latches.
2. To remove, pull frame forward and lift from bottom door retainer.
⚠
Cautions and Warnings
Do not clean when the glass is hot.
The use of substitute glass will void all product warranties (see
Glass Replacement
in this section).
Care must be taken to avoid breakage of the glass.
Do not operate this fireplace without the glass front or with a broken glass front.
Do not strike or abuse the glass.
Latch Assembly
46ZRB-123A
Small Door Latch
350-P400SA
37
All manuals and user guides at all-guides.com
