Kingsman FVF300, Руководство владельца по эксплуатации и установке

Страница: 18 / 24

18
LIGHTING INSTRUCTIONS
LIGHTING INSTRUCTIONS
1. Stop. Read safety information on page 6.
2. Open access door on bottom.
3. Push gas control knob in slightly and turn clockwise to “OFF”.
NOTE: Knob cannot be turned from “PILOT” to “OFF”
unless knob is pushed in slightly. Do not force.
4. Wait five (5) minutes to clear out any gas remaining in burner combustion chamber.
5. Turn knob on gas control counter-clockwise to “PILOT”.
6. Push control knob all the way in and hold. Immediately light the pilot with piezo-electric ignitor while continuing to hold knob in
for one (1) minute. Release knob. Pilot should remain lit. If it goes out, repeat steps 2 through 5 until pilot remains lit.
– If knob does not pop up when released, stop and immediately call your service technician or gas supplier.
– If pilot will not stay lit after several tries, turn the gas control knob to “OFF” and call your service technician or gas supplier.
7. Turn gas control knob counter-clockwise to “ON”.
8. All Millivolt models are supplied with a rocker switch that turns the main burner on or off. If main burner does not light
immediately when you turn the gas control valve to “ON” ensure that the wall switch is in the “ON” position.
NOTE: For Millivolt models, the “ON/OFF” wall switch may be replaced with a wall thermostat allowing main burner to light
and turn off automatically depending on thermostat setting and room temperature.
9. Adjust the gas flow (flame height) with the “HI/LO” gas control knob on valve.
10. Close control access door.
To Turn Off Gas Appliance
1. Turn off all electric power to the appliance if service is to be performed. Open control access door.
2. Push gas control knob in slightly and turn clockwise to “OFF” position. Do not force.
CAUTION
Do not wire 120 Volt power to Millivolt switches or
thermostats.
INSTALLATION OF BRICK PANEL KIT
1. Remove the top and front
as shown in the burner
install diagram.
2. Hold the rear brick panel
with both hands on the left-
right panel, tilt the top of
panel towards you slightly
and pull your right hand
towards you slightly and
place panel directly onto
the rear of the firebox.
NOTE: TAKE CARE NOT
TO DAMAGE PILOT
ASSEMBLY WHEN
PLACING REAR PANEL.
3. Loosen both brick clips
using 1/4” nut driver.
Swing brick clip out of the
way and position side brick
panel up to rear brick panel
and against side of firebox
and tighten brick clip down
onto panel. Repeat this
step with the other side
panel.
4. Install log set and front
door.
FIGURE 13 – Installing Brick Panels