HHO CARBON CLEANER 6.0 OPERATION MANUAL
11
5
off
machine stop working
6
on
machine start working
7
set
＋
start time setting
8
set
enter the time setting state
9
check
check accumulated working times
10
start
start producing gas
Over pressure indicator
: Once the pressure reaches 0.2mpa, the light on, machine
will stop producing gas. during carbon cleaning process, the light is not bright.
Over heat indicator
: when the electrolytic temperature is higher than set
temperature, the light on, machine will stop producing gas. The light is not bright
under normal conditions, unless the fan is not working or poor cooling.
Adding Water Indicator
: When the water level of water tank is low, Adding Water Indicator
will on. At this time, you need to open the cover at the top of machine, add water to the water
tank through the filling opening. Adding until the indicator light off, should stop adding water.
If Adding Water Indicator light turns on, but without timely adding water, it will cause to lack
of water and the machine will automatically shut down.
Set
: It is to set the time of carbon cleaning, the time setting is according to the time of
cleaning, normally 20 minutes.
Set
＋
: We assume the the four-digit timer display is shown as:AB:CD, first press the setting
button to enter setting mode. it displays D, you can press the timing button continuously the
digit D circularly ranges from 0 to 9. if you want to set the C digit,and then press the settings
button, the operation of setting A or B is the same. Under normal circumstances, set the
timer at 20:00 minutes.
Pressure gauge:
it is used for displaying the internal abnormal pressure value of carbon
cleaning machine supply system. Since catalyzed oxyhydrogen gas is vacuum inhaled into
the car engine, so the gauge keep the normal value; when excessive gas is gathered in the
machine, or external gas is blocked, the gauge pointer will rise when the pressure reaches
0.2Mpa. At then the machine will be in the state of protection, it will stop producing gas.When
the internal gas fully leak out, the machine automatically resume gas production
Note:
As the car model is FAW-Volkswagen Bora or Buick Excelle two models, if the machine
appears shut down constantly, because the vacuum tube is smaller than other car, it should
set the gas production as 700-800L/h; the machine can do carbon cleaning normal later.
If do carbon cleaning for diesel car, please connect with air filter, and use provided connector.
