Kingfisher KI7300 Series, Руководство по эксплуатации и обслуживанию

Страница: 23 / 66

RECORDING, STORING, RECALLING READINGS AND CLEARING MEMORY
KI7000 UM-5
-
21 -
Recording and storing data
To access memory locations, press [
◄►
]. To exit, press [Exit].
To record, press [M+]. Data will be stored in the next available
location. In Autotest, all test data will be stored in one location and
‘busy’ will be displayed while it is being recorded. If display is in Hold
mode, data on selected wavelength will be stored. To record data at
a particular location, press [
◄►
], then [-/+] to select the location,
[Set] and [M+]. This will overwrite any previous data stored there.
Recalling stored data
Note: return to ‘Menu’ to recall data recorded in Autotest mode. For
KI7600C/7300C/7700C Series, data recorded in Power meter and
Light source modes can be accessed in one of these modes or via
‘Menu’.
To recall recorded data, press [MR] and [-/+] to specify location.
For data recorded in Autotest, press [-/+] to view measurements at
all source wavelengths.
For each wavelength, to step through all available Autotest
measurements, select [MR], [-/+] and then press [
◄►
] repeatedly.
To display recalled value in dB R, press [Abs/Rel].
Clearing memory
A full memory at a particular location is indicated by activated buzzer.
To clear all stored data at selected location, press [MR] and [Exit]
simultaneously for 3 seconds. The buzzer will sound and display will
show ‘clr’.
Memory capacity (in Autotest)
Working memory capacity is determined by the configuration of your
instruments. The capacity of one instrument is illustrated in Table 1,
the combined capacity of the instrument pair (eg. two Loss Test
Sets) is ‘No of readings’ x 2:
Mode
No of source
wavelengths
No of readings
Autotest 2 3.408
Autotest 4 1.962
Figure 4.Memory capacity of a single Power Meter /Loss Test Set