21
FPLMP129
FPLMP129
Getting
Started . . .
Before you start
Fuel and engine oil
This product is equipped with a
4
-stroke engine. Before operation, it is necessary to add
suitable fuel and engine oil separately.
1. Place the product on a stable, level surface. We recommend laying a non-flammable
sheet under the product.
2. Use proper funnels. Avoid spilling and overfilling the tanks.
WARNING!
Fuel and oil are highly inflammable! Fumes will explode if lit!
Ensure that there are no naked flames around the product! Do not smoke
while filling fuel and oil!
3. Always dispose of fuel, used oil and objects contaminated with them in accordance
with local regulations.
Fuel
NOTE:
This product is not supplied with fuel! Before operating, it is essential
to fill it with fuel! Fill fuel and engine oil separately. Never mix oil with fuel!
1. Always use clean, fresh unleaded petrol. Purchase fuel in quantities that can be
used up within
30
days.
2. Avoid getting dirt, dust or water in the fuel tank (
6
).
3. Unscrew and remove the fuel tank cap (
6a
) (Fig.
6
).
4. Add suitable fuel into the fuel tank (
6
). Leave a minimum
5
mm of space between
the top of the fuel and the inside edge of the tank to allow for expansion (Fig.
7
).
7
6
5
mm
6a
6
NOTE:
Petrol deteriorates over time. It may be difficult to start the engine if
you use petrol which has been kept for more than
30
days. Towards the end of
the season, it is advisable to put only as much fuel in the tank (
6
) as you need
for each use since it should be completely used up before storing the product.
Always empty the fuel tank (
6
) when storing the product for over
30
days.
5. Wipe any spilt fuel with a soft cloth and reattach the fuel tank cap (
6a
).
NOTE:
Fuel can damage paint and plastic. When filling the tank (
6
), take care
not to spill any fuel. Damages caused by spills are not covered by the guarantee.
Engine oil
WARNING!
This product is not supplied with oil. However, for manufacturing
reasons, it is possible that a small quantity may be in the engine! Before
operating this product, it is essential to fill it with oil (
4
-stroke engine oil, e.g.
SAE 10W-30
)!
Engine oil has a significant influence on engine performance and service life.
Non-detergent or
2
-cycle engine oils will damage the engine and should not
be used.
1. Unscrew and remove the oil tank cap (
14
).
2. Gradually add good-quality engine oil (
SAE 10W-30
). Allow the oil to settle.
3. Check the oil level frequently while filling. Wipe off oil dipstick and insert it into the
tank opening without tightening the cap, and then remove the dipstick again.
4. The oil level must be between the oil level markings (approx.
400
ml). Add more oil
if necessary. Do not overfill (Fig.
8
).
max
min
8
14
5. After filling oil, wait
1
minute and then recheck the oil level.
6. Wipe the spilt oil with a soft cloth and reattach the oil tank cap (
14
).
3663602423270-GB-V04.indd 21
27/9/2018 10:06
