Kingarden LS10TG, Инструкция по эксплуатации

Страница: 8 / 19

8
unit several times till the oil in the hydraulic loop warms up.
Setting of the main control valve is done at manufacturer before
shipping. The unit comes to you ready for service so
that no other adjustment/installation work is required other than
assembly of the hand-guards on the control levers.
3.3 Initial check (before operating) (See Fig 1)
The log splitter is equipped with safety two-hands
mechanical controls designed for the operating to
keep both hands free from danger and from infringing.
Fig 1
the moving ram zone during the entire splitting cycle.
It is strongly recommended to check the operation of
the two-hands control every time before a new use.
To do so, engage both hand levers and hold them down at the same
time until the ram slides all the way down. If your system is duly set ,
the
wedge stops upon releasing or just one of the two levers
while the ram stops completing its up/down stroke at once.
On the other hand, the ram must recommence its upwards travel
to the initial start position (all the way up) as soon as the other levers
is also released.
Make sure that the ram does not travel down when operating only
one single lever.
Check that both lever spring back into their normal position when
the hand pressure is released
3.4 Start-up
Before first use, make sure that the log splitter is in good conditions
and that no visual damages are there.
Check all hydraulic hoses, fittings and coupling and to detect and
repair eventual oil leaks.
Make sure that all safeties and protections are duly assembled on
the machine. Do not attempt to remove or by pass these safeties!
Make sure the that the log splitter will not be damaged or made
unsafe by any operation, lubrication, maintenance, or repair
procedures that you choose .Should any trouble or unusual
behavior be detected, do not start splitting wood until these
have been fixed.
3.5 WARNING
1
）
The location you choose for your machine should be flat, dry, and
sold. Check around log splitter for hazards. Make sure that the area
is free of slippery surfaces and objects to over. Slippery and icy floor
conditions must be duly treated to assure solid standing conditions.
Also there are two holes on the two sides of ground table of log splitter,
they can be used for fixing by two bolts to avoid the machine fall off if it is not well placed.
Never reach with your hands at pinch points where they can get caught by the traveling wedge!
2）Never try to split such hard Across-the-Grain wood like
above picture and never try to split such Across-the-Grain wood
by continuously pressing operation handle or hand
lever over 2 seconds!! (see Fig 2)
Fig 2