Kingarden LS10TG, Инструкция по эксплуатации

Страница: 7 / 19

7
This splitter is conceived for splitter short and long logs for firewood
preparation only BEWARE; no cross. grain splitting is permitted .
Always split grain-wise.
When placing the log on the log splitter make sure that the chunk
rests entirely and safely on the riffle-plate table
Any other use or splitting method is considered by the manufacturer
as misuse. In case of misuse the manufacturer will not be held
entirely responsible.
Please make sure to comply with these set-up
.operation and
maintenance/repair instructions in order to avoid happening
of any injury or dangerous condition .
BEWARE: this unit has a log capacity of min 70 mm and max 350 mm diameter.
Danger! Keep clear of moving parts!
2.2 APPLICATION CONDITIONS
This log splitter is designed for operating under ambient temperatures
b5
℃
and 40
℃
and for installation at altitudes no more than
1000m above M.S.L. The surrounding humidity should less than
50
%
at 40
℃
.It can be stored or transported under ambient temperatures
between -25
℃ and 55℃.
2.3
Never dismantle and reassemble the log splitter by yourself unless
you are a professional engineer. Otherwise, the self-assembling may
lead to some dangers as below:
(1)Oil leak
(3)gasoline engine & pump damage
(2)No pressure (4)pressure is too big for cylinder endurance etc.
3. Operating instructions
3.1 Hand-guards assembly
Uncrate and assemble the special hand-guards on the hand control
levers before first use and installation.
The two hand control levers must be fixed to the two hand guards ,
that means the hand levers and hand guards must be assembled
as a whole with screws, then install them together to the machine for
operation. Make sure to tight all screws after complete guard assembly.
3.2 Hydraulic specs
The machine is equipped with own hydraulic oil tank located inside
the base-stand and is supplied by the manufacture with a first oil fill.
BEWARE: a leaning splitter position during transport may result into
oil leakage from the oil plug.
At low ambient temperature the oil in the hydraulic circuit will thicken.
In this case, it is recommended to avoid sudden start-up(splitting
without warming the gasoline engine up)that could result into damages and
trouble of the hydraulic system..
To assure trouble free operation of the hydraulic system at
low ambient temperature, let the gasoline engine run idle and cycle the