Kingarden LS10TG, Инструкция по эксплуатации

Страница: 10 / 19

10
3.8 Log clamps adjustment
（
see Fig 6
）
In order to hold the log firmly under the wedge during
the entire splitting. cycle, use the special log-clamps
located on each hand control lever. Both Log clamps
are adjustable depending on lo diameter and size and
in case In order to adjust the clamps position first release
the clamp on each side.
Once adjusted to the desired position lock the clamps into
Fig 6
position by tightening the knob again.
log clamps
3.9 GAS ENGINE START UP GUID
BEFORE STARTING.check and fill engine with approximately 0.6 litres
SAE10W-30 oil.Fill the fuel tank with 93+octane unleadedgasoline
NOTE:This engine includes an automatic low oil shutdown
sensor that disables the engine if the oil level is too low
Starting The Enging:
1. Open The Gas Valve By Moving To The Right.
Close The Choke By Moving it To The Left.
Note:If The Engine Is Already Hot,It Is Not Necessary To Close The Choke.
Open The Throttle By Moving To The Left(Rabbit Symbol) See Bottom Photo.
2. Turn The Engine Switch To The On Position.
3. Gently Pull The Recoil Starter Handle Until It Engages,Then Pull It All The Way Out
In A Rapid Pull.May Take 5 pulls To Start.
Once The Engine Starts,Move The Choke To 1/2 choke Position.
After 15 Seconds,Open Choke By Moving To Right.
Note:Moving The Choke Too Fast Can Kill The Engine.
4. Adjust The Throttle To The Speed You Desire.
IMPORTANT:Allow The Engine To Warm Up With No Load For At Least
1Minute After Each Start-Up.
Stopping The Enging:
1. Move The Throttle Lever To The Right(Idle Position).
2. Turn The Engine Switch To The OFF Position.
3. Close The Gas Valve By Moving To The Left.