Figure 3
PKB SETUP INSTRUCTIONS
Rating Label Location
1. Setting up Your Heater:
2. Unpack and inspect your heater for any damage. Any
damage discard heater or return to authorized
service facility immediately.
3. Place heater at least 6" (15cm) away from vertical
surfaces and keep the intake
DQGH[KDXVW
clear of
obstructions.
Keep all combustible materials, such
as furniture,
papers, clothes, drapes, and curtains
at least 3 feet
(0.9 m) from the front of the heater
and keep them
away from the sides and rear.
4. Route power cord away from traffic areas to avoid
tripping. NEVER rout
H
power cord under carpets,
rugs, drop
FORWKV
furniture or other equipment.
5. Plug power cord into a grounded wall outlet only DO
NOT use an extension cord or power strip.
6. Wiring diagram located in wiring
FRPSDUWPHQW
7.
2XWVLGHXVDJH5DLQKRRGDQGGRRU3&.5%PXVW
EHXVHGIRURXWVLGHXVH
8. WARNING: This heater is floor ONLY and should not
be tipped on side, placed upside down, mounted on
or inserted into a wall. A tip over auto disconnect
switch will activate when tipped more then 30°.
9. DO NOT use heater in areas where gasoline, paint,
or other flammable liquids are used.
10.
:KHQ
WKHUDLQNLW
3&.5%
LVLQVWDOOHGPDNH
VXUHFRYHUV
DUHIDVWHQHGZLWKWKHSURYLGHG
UXEEHUVHDOLQJ
ZDVKHUVIRUWKH
DFFHVV
GRRU
11. Store unplugged and in a dry indoor location.
12.
7KHSURSHUWZLVWORFNFRUGFRQQHFWLRQKDVEHHQ
SURYLGHGDQGORQJHUFRUGVFDQEHDGGHG'RQRWFRLO
XSWKHH[WHQWLRQFRUGZKLOHWKHKHDWHULVLQ
RSHUDWLRQKHDWLVPXOWLSOLHGZLWKHYHU\WXUQDQGZLOO
PHOWWKHFRUG
ELECTRIC SHOCK OR FIRE HAZARD
DANGER
!
!
2
Figure 2
)LJXUH
3DUW
%
$9$&9
SROHZLUHFRQQHFWRU
$:HDWKHUSURRI%RRWV
$
,3
$&
SROHZLUHSOXJ
&$87,21
7XUQ2))EUHDNHUWRUHPRYHDQG
XQSOXJJLQJWKHKHDWHUZKLOHVHWWLQJXSRU
SODFLQJLQQHZORFDWLRQ
:HDWKHUSURRISOXJDQGFRQQHFWRUV
+XEEOH0RGHOV
3DUW&6&
9SKDVH
3DUW+%/&
3DUW+%/&
$9$&
SROHZLUHSOXJ
$:HDWKHUSURRI%RRWV
3DUW+%/
%
3DUW+%/%
3DUW+%/
)LJXUH
)LJXUH
3DUW
&6&9SKDVH
3DUW&6&9SKDVH
3DUW&69SKDVH
$9$&SROH
ZLUHFRQQHFWRU
3
2
1
（
）
-
!
!
-
-
!
!
-
-
Rev. 2.27.18
-
-
Time Period Mode
1
（
）
-
!
!
-
-
!
!
-
-
Rev. 2.27.18
-
-
Time Period Mode
General information and Guidelines:
This heater must be properly placed before it is used.
DO NOT tamper with or change the operating of this
heater. All service should be preformed by a authorized
service representative. Only replace components with
King approved replacement parts.
Operation:
1. After the electric heater has been
VDIHO\ORFDWHG
,
thermostat should be turned to LOW or
NO HEAT.
Plug unit into grounded outlet, wait 3 to 5
minutes
and check to
see that the heater
LV
not
operating. If
operating,
disconnect power and check
for improper
wiring. If
no
W
operating then turn
thermostats to
highest
position and wait 3 to 5
minutes. Check to
see that
WKH
OPERATING INSTRUCTIONS
Unit or Series
3
SAVE THESE INSTRUCTIONS
heater
LV
operating. Should
LW
not be
operating,
disconnect power and check wiring.
2. Allow entire system to operate steadily for 1/2 hour.
This should remove oily residue from manufacturing.
(Some smoking may occur
IURPHOHPHQW
).
3. Select the setting for comfort
RU\RXUMREUHTXLUHPHQW
4.
A safety limit control is provided to turn off the
heater
HOHPHQWV
automatically if it is blocked or
otherwise
overheats due to an abnormal condition.
DO NOT
bypass or remove this safety
OLPLWLQJ
device
from the
electrical circuit. During normal use, this
safety
control should not operate. If you find that
this
control is operating, make sure the heater is not
being blocked
RUILOWH
ULV
SOXJJHG
. If it continues to
cycle the heater
HOHPHQWV
off, disconnect power to
heater and
have it checked
and repaired by a
qualified
electrician.
Table
Troubleshooting Chart for Electric Heaters
SYMPTOM
PROBLEM
SOLUTION
Breaker Trips
1. Short Circuit
2. Overloaded Circuit
3. Improper Voltage
1.
Find source of short. Trace heater circuit and verify the heater is wire properly.
2.
Reduce wattage in circuit. Refer to circuit sizing table for maximum wattage.
3.
Verify the heater voltage matches the supply voltage.
Heater not working 1.
No Power
2.
Loose Connections
3.
Defective Limit
1. Turn Breaker ON, turn thermostat ON, check that the breaker is position
properly on panel bus-bar. A 2-Pole breaker must be connected to both bus-
bars (A&B phase) to produce 240V power.
2. Tighten wire connections.
3. By-pass the limit to test. If heater works, replace the limit.
Heater Smokes
1.
Oil on Element
2.
Needs Cleaning
1. It is normal for the element to burn off some light finishing oil used in the
manufacturing process when first energized. Open windows and allow room
to vent until it stops, usually within a few minutes.
2. Remove any dust or dirt accumulations.
Room Temperature
does not match
thermostat setting
1. Thermostat affected
by another heat
source.
2. Improper calibration
1.
Sunlight or other heat sources can affect the thermostat. Move the thermo
stat to another location or remove the heat source.
2.
Remove cover and adjust calibration screw.
Room Temperature
swings from too hot
to too cold
1. Defective or low
quality thermostat
1.
Replace with a better quality thermostat. Anticipated thermostats are fair-
ly accurate; an electronic thermostat is best.
PCKF SETUP INSTRUCTIONS
Figure 3
PKB SETUP INSTRUCTIONS
Rating Label Location
1. Setting up Your Heater:
2. Unpack and inspect your heater for any damage. Any
damage discard heater or return to authorized
service facility immediately.
3. Place heater at least 6" (15cm) away from vertical
surfaces and keep the intake
DQGH[KDXVW
clear of
obstructions.
Keep all combustible materials, such
as furniture,
papers, clothes, drapes, and curtains
at least 3 feet
(0.9 m) from the front of the heater
and keep them
away from the sides and rear.
4. Route power cord away from traffic areas to avoid
tripping. NEVER rout
H
power cord under carpets,
rugs, drop
FORWKV
furniture or other equipment.
5. Plug power cord into a grounded wall outlet only DO
NOT use an extension cord or power strip.
6. Wiring diagram located in wiring
FRPSDUWPHQW
7.
2XWVLGHXVDJH5DLQKRRGDQGGRRU3&.5%PXVW
EHXVHGIRURXWVLGHXVH
8. WARNING: This heater is floor ONLY and should not
be tipped on side, placed upside down, mounted on
or inserted into a wall. A tip over auto disconnect
switch will activate when tipped more then 30°.
9. DO NOT use heater in areas where gasoline, paint,
or other flammable liquids are used.
10.
:KHQ
WKHUDLQNLW3&.5%LVLQVWDOOHGPDNH
VXUHFRYHUVDUHIDVWHQHGZLWKWKHSURYLGHG
UXEEHUVHDOLQJZDVKHUVIRUWKHDFFHVVGRRU
11. Store unplugged and in a dry indoor location.
12.
7KHSURSHUWZLVWORFNFRUGFRQQHFWLRQKDVEHHQ
SURYLGHGDQGORQJHUFRUGVFDQEHDGGHG'RQRWFRLO
XSWKHH[WHQWLRQFRUGZKLOHWKHKHDWHULVLQ
RSHUDWLRQKHDWLVPXOWLSOLHGZLWKHYHU\WXUQDQGZLOO
PHOWWKHFRUG
ELECTRIC SHOCK OR FIRE HAZARD
DANGER
!
!
2
Figure 2
)LJXUH
3DUW
%
$9$&9
SROHZLUHFRQQHFWRU
$:HDWKHUSURRI%RRWV
$
,3
$&
SROHZLUHSOXJ
&$87,21
7XUQ2))EUHDNHUWRUHPRYHDQG
XQSOXJJLQJWKHKHDWHUZKLOHVHWWLQJXSRU
SODFLQJLQQHZORFDWLRQ
:HDWKHUSURRISOXJDQGFRQQHFWRUV
+XEEOH0RGHOV
3DUW&6&
9SKDVH
3DUW+%/&
3DUW+%/&
$9$&
SROHZLUHSOXJ
$:HDWKHUSURRI%RRWV
3DUW+%/
%
3DUW+%/%
3DUW+%/
)LJXUH
)LJXUH
3DUW
&6&9SKDVH
3DUW&6&9SKDVH
3DUW&69SKDVH
$9$&SROH
ZLUHFRQQHFWRU
Make sure covers are fastened with the provided
rubber sealing washers for the access door.
