Positioning the Juicer
■
Always place the appliance at the back of the kitchen counter.
■
Do not place this appliance on or near a hot gas or electric burner, or where it could
touch a heated oven.
■
Cord, plug and mains socket
■
Ensure that the cord is fully extended.
■
Do not allow the cord to hang over the edge of a table/counter, or touch hot surfaces
or become knotted.
■
Check regularly that neither cord nor plug is damaged and do not use if they are, or if
the appliance has been dropped or damaged in any other way.
■
If the appliance or plug is damaged, it must be inspected and if necessary, repaired by
an authorized repair engineer, otherwise there is a risk of electric shock. Never try to
repair the appliance yourself.
■
Avoid pulling the cord when removing the plug from the socket. Instead, hold at plug.
■
Check that it is not possible to pull or trip over the cord or any extension cord.
■
This appliance has a polarized plug (one blade is wider than the other). To reduce the
risk of electric shock, this plug will fit in a polarized outlet only one way. If the plug does
not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician. Do not modify the plug in any way.
USING THE APPLIANCE
Assembly before use:
■
Place the motor section (3) on a flat surface, e.g. a kitchen counter, and make sure it
is standing firmly on the four suctioned feet.
■
Place the base (6) on the motor section so that the spout (5) fits in the slot on the side
of the motor section.
■
Push the fruit pulp holder (2) up under the drain edge on the base so that it locks on
the foot of the motor unit tightly.
■
Carefully lock the Stainless Steel Filter Basket (7) onto the base.
■
Be careful not to touch the sharp parts in the bottom of the Stainless Steel Filter
Basket.
■
Make sure that the Stainless Steel Filter Basket sits properly on its base, so that the
gear on the bottom of the basket engages the gear in the base.
■
Make sure that the Stainless Steel Filter Basket is secured on the base and it rotates evenly.
■
Place the lid (10) on the appliance so that it covers both the fruit pulp holder and the
Stainless Steel Filter Basket. Make sure that the lid fits tightly onto the base.
