KING KD1500, Руководство пользователя

Страница: 12 / 36

Page 10
Section 3
ANTENNA CONFIGURATION
The KING Rover is factory pre-set for DIRECTV standard digital programming broadcast from the
101° W satellite ( DIRECTV SD ). If you also receive your local channels from DIRECTV’s 119 satellite
or if you subscribe to DISH or Bell TV programming, you must configure the antenna to work with
your satellite service. Doing this will allow the KING Rover to lock on the correct satellites to receive
your programming and also enable automatic satellite switching via the receiver’s remote control for
multi-satellite service.
Antenna configuration is a one time procedure that
MUST BE COMPLETED
before using your
KING Rover antenna. To configure your antenna, do the following:
1. Press POWER to turn on KING Rover controller. The COAX CONNECTION light will flash
10 times and then turn on, and the SCAN PROGRESS lights will flash 3 times to indicate the
selected service configuration .
2. Simultaneously press and hold POWER and SCAN for five seconds.
The COAX CONNECTION light and the SCAN PROGRESS lights that indicate the currently
selected service will begin flashing.
NOTE: If you have DIRECTV SD service you do not need to configure your antenna. Go to step 5 on next page.
NOTE:
If you have a DISH receiver
ViP211z
,
ViP211k
,
ViP211
or
411
,
FIRST
choose the
TAILGATER
MODE
setting as instructed on these two pages, and then continue with Tailgater Mode
(Section 7, page 20).
To verify the current service configuration without changing it, perform steps 1, 2 and 4.