King Long XMQ6129Y series, Руководство по эксплуатации

Страница: 40 / 161

Technical parameter and complete vehicle description
0-T-1
when towing.
CAUTION
For towing purposes, always disconnect the propeller shaft
flange from the rear axle before setting off. If it cannot be
disconnected, remove both stub shafts.
Avoid polluting the environment in the event of oil loss.
1.12 Tow-starting
The engine
cannot
be tow-started.
1.13 Clutch protection
«
CL
» is displayed if there is a risk of clutch overload
resulting from several starting process occurring in
rapid succession or of crawling in too high a starting
gear.
NOTE
Select an operating mode in which the clutch will not be
overloaded, for example:
➢
accelerate vehicle (to close the clutch)
➢
stop the vehicle
➢
set off briskly in a lower gear
➢
To conserve the mechanical components of the clutch
release device, the transmission should be shifted to
neutral if the vehicle stops for long periods of time
(for more than approx. 1 to 2 min., for example, in
traffic jams, at railway crossings etc.).This closes the
clutch and relieves the clutch release device.
Even though the clutch is automated, the driver still has
considerable influence on clutch service life. To keep
levels of wear on the clutch low, we would recommend
that
when setting off, you always select the lowest
gear possible.
1.14 Engine overspeed protection
The electronics system only allows shifts to be
undertaken if they lie within the speeds specified by
the vehicle manufacturer. This is done to the benefit of
both engine and transmission.
1.14.1 Manual mode
➢
If the vehicle accelerates on downhill gradients,
an
automatic shift is not made
into a higher gear.
➢
Ensure that the engine does not exceed the
permitted speed range.
CAUTION
The engine may be damaged if the vehicle is accelerated on
downhill gradients and the engine thereby enters the
overspeed range.