ELECTRICAL INFORMATION,
TRANSPORTATION & CLEANING
WARNING
ALL ELECTRICAL CONNECTIONS MUST BE DONE BY A QUALIFIED ELECTRICIAN. FAILURE TO COMPLY MAY RESULT IN SERIOUS
INJURY! ALL ADJUSTMENTS OR REPAIRS MUST BE DONE WITH THIS DRILLING MACHINE DISCONNECTED FROM THE POWER
SOURCE. FAILURE TO COMPLY MAY RESULT IN SERIOUS INJURY!
POWER SUPPLY
WARNING:
YOUR DRILLING MACHINE MUST BE CONNECTED TO A 550V (3 PHASE) CIRCUIT. FAILURE TO CONNECT IN THIS WAY
CAN RESULT IN INJURY FROM SHOCK OR FIRE.
GROUNDING
Your drilling machine must be properly grounded. Not all outlets are properly grounded. If you are not sure if your outlet is properly
grounded, have it checked by a qualified electrician.
WARNING:
IF NOT PROPERLY GROUNDED, THIS DRILLING MACHINE CAN CAUSE ELECTRICAL SHOCK, PARTICULARLY WHEN
USED IN DAMP LOCATIONS. TO AVOID SHOCK OR FIRE, IF THE POWER CORD IS WORN OR DAMAGED IN ANY WAY, HAVE IT
REPLACED IMMEDIATELY.
This drilling machine must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric
current, to reduce the risk of electric shock.
WARNING:
TO MAINTAIN PROPER GROUNDING OF YOUR DRILLING MACHINE, DO NOT REMOVE OR ALTER THE GROUNDING
PRONG IN ANY WAY.
550V (3 PHASE) OPERATION
As received from the factory, your drilling machine does not come with a 550V CSA plug. The user must purchase a 550V CSA approved
plug and have it installed. Contact your authorized service center or qualified electrician to install the plug. Make sure the 550V plug
installation complies with all local and national codes.
Check with local codes for requirements for independent circuits and dedicated power control switch.
TRANSPORTATION USING LIFTING EQUIPMENT
To move this drilling machine from one location to the
other, start by removing the transversal hole plastic
covers (one on each side of the head). Insert a high grade
steel bar through the transversal hole (A-Fig.1) in the
machine head and attach a rope in order to lift the drilling
machine using a chain hoist.
FASTENING BASE TO FLOOR
Figure 2 shows the method and dimensions required for
fastening the drill press base to a level floor.
CLEANING
After removing the drilling machine from its wooden crate
and fixing it permanently to the floor, all the surfaced
(non-painted) parts of the machine are coated with an
anti-rust compound and must be cleaned. Clean with a
rag and kerosene or a petroleum base solvent, then
lubricate all movable parts with gear oil or grease.
FIGURE 1
FIGURE 2
A
B
C
D
E
16 1/8”
28 3/4”
14 1/8”
16 1/8”
4 1/2”
