ASSEMBLY
1. Install the four casters to the under side as illustrated in Fig.1.
Do not remove the lock washers and nuts from caster roller
shafts; these act as spacers. Insert roller shaft into threaded
hole on the underside of the base, turn until it is snug, then
tighten nut with wrench.
2. Place base with rollers on the ground and attach the motor and
fan assembly to the base using 4 hex. bolts and 4 flat washers.
(Fig.2)
3. Attach inlet cover to fan housing using 8 pan hd. screws.
(Fig.3).
4. Attach the three support brackets (Fig.4) to the base using 6
hex. bolts and 6 flat washers. Hand tighten only at this point.
FIGURE 1
FIGURE 2
FIGURE 3
FIGURE 4
