ASSEMBLY
ASSEMBLING EXTENSION WINGS
Assemble the Table Extension Wings to your saw as follows:
Fasten extension wings to the table (underneath the table and extension) using
six hex. head bolts and lockwashers supplied. Use a straight edge to level the
extension wings to the table surface as shown in fig. 2. Also make sure the
extension wings are flush with the front edge of the table.
SWITCH INSTALLATION
The switch assembly comes uninstalled and must be installed to the inner lip of
the left extension table. Place switch plate (A) Fig.2A against the front inner lip
of the left extension table and align with mounting holes. Fix switch plate (A) to
extension table (B) using 2 washers, spring washers and hex. bolts (C).
ASSEMBLING BLADE GUARD AND SPLITTER
WARNING!
NEVER OPERATE SAW WITHOUT BLADE GUARD IN THE
PROPER OPERATING POSITION. FALIURE TO DO THIS MAY CAUSE
SERIOUS INJURY!
1. Thread nut (B) Fig.3 on threaded end of rod (A) and insert threaded end of
rod (A) through hole in casting and carriage at rear of machine. Tighten
securely with a wrench.DO NOT tighten nut (B) yet.
2. Assemble lower rear bracket (C) to rod (A).
3. Using wrench, loosely secure two hex. bolts (D) located under lower rear
bracket (C).
4. Using hex. bolts, lockwashers and hex. nuts (E), loosely attach splitter
bracket (F) to lower rear bracket (C).
5. Assemble blade guard assembly (G) to splitter bracket (F) using hex. bolts,
lockwashers and hex. nuts (H).
6. Align front of splitter (I) with blade kerf (blade path/ blade must be installed,
see blade installation) using straight edge and tighten nut (B) against the
casting. When splitter aligns with blade and is square with table, tighten all
hex. bolts and hex. nuts (D & E).
7. The last step is to mount the front of the splitter to the inner bracket found
in the table insert opening. Mount splitter to inner bracket using hex. bolt,
washer and hex. nut.
WARNING!
SOME CUTTING OPERATIONS (DADO BLADE, MOLDING CUTTERHEAD)
WON’T ALLOW USE OF BLADE GUARD AND SPLITTER ASSEMBLY. USE
EXTREME CAUTION DURING THESE OPERATIONS AS THE BLADE OR
CUTTERHEAD WILL BE EXPOSED AND COULD CAUSE SERIOUS INJURY.
ASSEMBLING OPTIONAL RIP FENCE SYSTEM
King Canada has developed optional Industrial Rip Fence Systems models
KRF-10/30L12 (30” rip) and KRF-10/52L12 (52” rip) for your table saw. To
assemble these Rip Fence Systems or another, please follow the assembly
instructions found in the Rip Fence instruction manual. As reference only, Fig.4
illustrates the King Canada Industrial Rip fence System assembly along with the
installation of an optional 32” Extension table model EXT-32 or a 24” Router
Extension table model KC-24RT.
FIGURE 2
FIGURE 3
FIGURE 4
FIGURE 2A
