ASSEMBLY
WARNING
: To avoid injury, if any parts are missing, do not attempt to assemble
the bandsaw, plug in the power cord, or turn the switch on, until the missing parts
are obtained and installed correctly.
WARNING
: For your own safety, never connect plug to power source outlet, or
insert switch key until all assembly steps are complete and until you have read
and understood the entire instruction manual.
ASSEMBLING STAND
Refer to Fig.4 to assemble stand.
1) Use carriage bolts and hex.nuts to assemble stand. Only hand-tighten hex.nuts
at this time.
2) Make sure the two short support plates (A) Fig.4 with extra holes are opposite
one another as shown.
3) Slip rubber feet (B) onto ends of stand legs.
4) Place stand upright on level floor, and push down until it sits evenly.
5) Tighten all hex. nuts.
MOUNTING BANDSAW ON STAND
Refer to Fig.4 to mount bandsaw on stand.
1) Align holes on bandsaw base with holes in stand. Mount bandsaw to stand
using three cap screws, washers and hex.nuts, as shown in Fig.4. Tighten hex.
nuts.
INSTALLING THE TABLE
1) Position the table (A) Fig.5 to allow the blade to slide into the table slot. Slide
the blade through the slot in the table and then place the table onto the
bandsaw trunnion (B).
2) Align the four mounting holes of the table with the ones in the trunnion.
3) Fasten the table to the trunnion using four flange hex. bolts (C) Fig.5.
FIGURE 4
FIGURE 5
