SIMPLIFIED LEARNING PROCEDURE
1. Determine the initial settings to be pre-set.
2. Programme the remote controls (if present) according to this sequence:
a) Press P2/RAD for two seconds: the corresponding red LED lights up.
b) Make a transmission with each remote control using the chosen button (channel).
c) Press P2/RADIO to exit the programming.
Force/Speed
(FOR)
Reg. from 50
to100%
3
Place the door in the
intermediate position
RESET:
Press pushbutton
P1/SET for 2 sec.
Yellow LED
flashes
Within 5 seconds
press pushbutton
P1/SET for 1 sec.
Yellow LED on with
fixed light
The control unit
commands a brief
reduced speed
opening
If motor turns in
reverse invert wires
and start procedure
again from RESET.
Adjust trimmers if necessary
ATTENTION
A trimmer variation “FOR” (speed)
requires the repetition of the learning procedure from RESET (vary the manoeuvre time).
The slowing down is defined automatically in the last 10% of the manoeuvre. With only enco-
der present, terminate manoeuvre by pressing P1/SET pushbutton on board or with channel 1
of memorised remote control before obstacle detection intervention
Closes at reduced
speed until electrical
limit stop
Opens until the limit
stop
Closure until electri-
cal limit stop.
Yellow LED
turns off.
Pause for
1 second
End of learning
procedure
TRIMMER
Pause Time
(PAU)
Reg. from 0 to
60 sec.
Obstacle Sensitivity
(OBS)
Reg. obstacle
intervention time
from 0.1 to 3 sec.
CONTROL UNIT INITIAL SETTINGS (Dip-switches)
���
��
���������
�������
�����������������������
����������������������
�����������
���������
����������������������������������
����������������������������������������
��������
�������
��
�������
�����������������������������
�������������������������������
���
��
��
���������
�������������
���
