Sanding Sleeves and Discs
These sleeves and discs can be used for any small sanding need you may have. The
drum sander (drum and sanding sleeve) can shape wood and sand inside curves or
other difficult places.
Stainless steel Brush and Bristle Brushes
Important note: All brushing applications require lower speeds to avoid wire discharge
from the holder. Stainless steel brushes perform well on aluminum, stainless steel and
other metals, witout leaving “after-rust”. Bristle brushes are good for general purpose
cleaning.
High Speed Cutter, Engraving Cutters and Drill Bits
High speed cutters are used in carving, cutting and slotting wood, plastics and soft
metals. Engraving cutters are used for intricate work on ceramics, wood carvings and
jewelry and drill bits are used to punch holes in just about any type of wood and wood
composites. Different sized drill bits will require the appropriate collet to be used.
Abrasive discs
These abrasive discs are used for slicing, cutting off and similar operations.
OPERATING SPEEDS
& ACCESSORIES
Material
Wood
Steel
Aluminum, Brass
Plastic
Speed Setting
6
1
3
1
Sanding Sleeves and Discs
Material
Stone
Aluminum, Brass
Speed Setting
2
2
Brushes
Material
Stone
Steel
Aluminum, Brass
Plastic
Speed Setting
Max
3
6
1
Cutters and Drill Bits
Material
Steel
Aluminum, Brass
Plastic
Speed Setting
5
3
5
Abrasive Discs
Servicing
Warning!
Preventive maintenance performed by unauthorized personnel may result in
misplacing of internal wires and components which could cause
serious injury and
will void warranty.
Cleaning
To avoid accidents always disconnect the tool from the power source before
cleaning or performing any maintenance.
The tool is most effectively cleaned using
compressed air. Ventilation openings and switch levers must be kept clean and free of
foreign matter.
Certain cleaning agents and solvents damage plastic parts,
such as gasoline,
carbon tetrachloride, chlorinated cleaning solvents, ammonia and household
detergents which contain amonia.
Carbon Brushes (Fig.6)
The brushes (A) Fig.6 and commutator in your tool have been engineered for many
hours of dependable service. To maintain peak efficiency of the motor, we recommend
that the brushed be inspected after 50-60 hours of use.
If the carbon brushes are less than 1/8” long, replacement brushes are needed, only
use identical replacement brushes available through your nearest King Canada
service centre.
Lubrication
Your rotary tool requires no additional lubrication.
ROTARY TOOL
MAINTENANCE
Figure 6
