Kinderkraft I-GUARD, Руководство пользователя

Страница: 49 / 188

49
5.3 Securing the child with a 5-point seat harness
• Loosen the harness completely by pressing the button (4) and pulling the harness. Do not
pull on the shoulder cushions.
• Release the buckle (3). Hook the 5-point harness on the harness holders (11), which are
located at the sides of the seat (fig. B.3). Position your child in the seat.
• Adjust the headrest to the child's height (see section 5.0).
• Fold the two buckle clasps together to interlock and insert them into the buckle (3) until you
hear a ‘click’.
5.4 Tightening of 5-point safety harnesses
• Pull on the shoulder straps to eliminate any play in the hip area so the belt lies flat.
• Tighten the 5-point harnesses with the adjusting belt (5) until the harnesses lie flat on and
close to the child's body. Ensure that the shoulder straps are snug against the child's
shoulders. Proper tension is ensured when, in the space between the shoulder straps and the
child's chest, a maximum of one finger (approx. 1 cm) can be inserted between the straps and
the child's body (fig. B.4).
NOTE: The 5-point harnesses must be positioned as low as possible on the child's hips. Make
sure the harness is not twisted.
5.5 Insert
A child insert not only improves comfort and gives extra support for very young children but
also serves to protect the child. The insert must be used until your child is 60 cm tall (fig B.5).
When your child reaches a height of 60 cm, the insert must be removed (fig B.6).
Remember: An insert is a complete unit and you must not modify it in any way. Store the child
insert in a safe place for future use. NOTE: Only use this original Kinderkraft I-GUARD insert.
This insert is only intended for use with the I-GUARD seat.
5.6 Removing the seat (ISOFIX attachment support leg)
• To release the support leg support (9), press the supp ort leg height adjustment button (17).
Grasp the foot (10) and slide it back into the support leg.
• Press the release button (15) located on both ISOFIX attachments. The attachments will be
released and the colour of the ISOFIX indicators (15) will change from green to red. Retract
the ISOFIX attachments using the shift lever (12), slide them back into the seat base by
exerting pressure on the attachments towards the seat, so that they engage in the seat base,
do this on both sides of the seat.
6.0 Removing/fitting the cover
• Removing the covers of the inner belts: undo the hook -and-loop fastener on the inside of
the covers and remove the covers, which are hooked to the metal hooks (fig. C.1).
• Removing the back and the seat cover: detach the four tensioning fasteners securing the
cover to the back part of the seat backrest (fig. C.2, C.3). Remove the cover from the side
covers by sliding the fabric (fig. C.4).