BATTERYLESS JUMP STARTER
5
Understanding the Features of Your Batteryless Jump Starter (Cont.)
Note: The Batteryless Jump Starter should automatically detect a 12V or 24V DC battery once connected to the
battery terminals. The battery voltage of the battery being used to charge the battery can be identified by the 12 /
24V Mode Indicator (5). Follow the below charging procedures based on the battery being used to recharge your
Batteryless Jump Starter.
1. Pre-Charge Methods
1. 12V DC Battery Source for 12V Vehicle Jump Start - Connect the Batteryless Jump Starter to a charged 12V
DC battery by connecting the Positive Battery Clamp RED (1) to the positive battery terminal of the 12V DC
battery, then connect the Negative Battery Clamp BLACK (2) to the negative battery terminal of the 12V DC
Battery, and press the ON / OFF Button (4), the Batteryless Jump Starter will begin charging automatically &
be fully recharged in minutes.
2. 24V DC Battery Source for 24V Vehicle Jump Start - Connect the Batteryless Jump Starter to a charged 24V
DC battery by connecting the Positive Battery Clamp RED (1) to the positive battery terminal of the 24V DC
battery, then connect the Negative Battery Clamp BLACK (2) to the negative battery terminal of the 24V DC
Battery, and press the ON / OFF Button (4), the Batteryless Jump Starter will begin charging automatically &
be fully recharged in minutes.
Note: If the Fault / Bypass / Glow Indicator (7) is displayed during the charging process at any stage, the battery
being used cannot fully recharge the Batteryless Jump Starter. Review & confirm the fault LED sequence, then
determine the reason for the fault LED being illuminated in Understanding J / Starter Features on page 4.
Note: The Batteryless Jump Starter can be recharged from either a 12V DC battery or a 24V DC battery. If you are
charging the Batteryless Jump Starter for a 24V purpose, however you are pre-charging the unit from a 12V DC
battery, follow the below operation.
3. 12V DC Battery Source for 24V Vehicle Jump Start- Connect the Batteryless Jump Starter to a charged 12V
DC battery by connecting the Positive Battery Clamp RED (1) to the positive battery terminal of the 12V DC
battery, then connect the Negative Battery Clamp BLACK (2) to the negative battery terminal of the 12V DC
Battery, and press the ON / OFF Button (4), the Batteryless Jump Starter will begin charging automatically
and charge to 14V.
4. After the Batteryless Jump Starter has charged to 14V you will need to press & hold down the ON / OFF Button
(4) for 4 seconds to select the 24V function & the Batteryless Jump Starter will recommence charging
up to 28V.
5. The Batteryless Jump Starter is now fully charged and able to start a 24V system vehicle.
Operation Guide
WARNING! DO NOT crank the vehicles engine for more than 3-5 seconds per cranking/starting attempts.
WARNING! The Batteryless Jump Starter must be allowed to cool 20 mins after 3 consecutive cranking
sessions, failing to do so may cause damage to the Batteryless Jump Starter. Damage caused is not
covered under the Kincrome warranty policy.
Caution: If the vehicle fails to start within the 3-5 seconds, there maybe a reason other than a flat battery to why
your vehicle is not starting. Seek further advice from an automotive repairer to identify the cause (Any such costs
associated with seeking advice from an automotive repairer is not covered by Kincrome).
WARNING! Disconnect the Batteryless Jump Starter immediately after the vehicles’ engine has started.
