7
AIR/HYDRAULIC BOTTLE JACK
OFFICE CONTACT DETAILS:
Phone:
1300 657 528
Fax:
1300 556 005
Email:
Website: www.kincrome.com.au
TROUBLE SHOOTING
Symptom
Cause
Remedy
Jack will not lift load.
1. Release Valve (4) not fully closed.
2. Oil level low.
3. Air supply low.
1. Close Release Valve (4) firmly.
2. Top-up to correct level.
3. Adjust the compressors air pressure
between 115psi to 175psi
Jack will not hold load.
1. Release valve (4) not fully closed.
2. Overload condition
3. Hydraulic unit malfunction
1. Close Release Valve (4) firmly.
2. Remedy overload condition
3. Contact Kincrome customer Service
Jack will not lift smoothly or to
full height.
1. Oil level low.
2. Air in hydraulic system.
1.Top-up to correct level.
2. Bleed system - Bleeding / Venting
Trapped Air on page 4.
Jack will not lower completely.
1. Release Valve (4) not sufficiently open.
2. Reservoir overfilled
1. Slowly open valve further.
2. Check oil level
Notes:
Warranty given by Kincrome Australia Pty Ltd of 3 Lakeview Drive, Caribbean Park, Scoresby, Victoria (Tel 1300 657 528). The applicable warranty
period (12 months) commences on the date that the product is purchased. If this product has materials or workmanship defects (other than defects
caused by abnormal or non warranted use) you can, at your cost, send the product to place of purchase, an authorised Kincrome service agent or one
of Kincromes addresses for repair or replacement. Your rights under this warranty are in addition to any other rights you have under the Australian
Consumer Law or other applicable laws. Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled
to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure. For further
details please visit www.kincrome.com.au or call us. Due to minor changes in design or manufacture, the product you purchase may sometimes differ
from the one shown on the packaging.
Содержание K12130
Страница 8: ...www kincrome com au...
