KPC 3k and 15k
MAN08152022
04
Press MODE
“-HoL-”
Upper weight limit setting.
(*Press “MODE” to skip this step and enter into next step.)
Press “→T←” to enter into upper weight limit setting. Screen
will display “0”(upper limit setting) and “HI” symbols.
Press “→T←” to enter into upper weight limit setting,
“000000” will display; press →T← to select position and
“→0←” to change data.
Press MODE to confirm the upper limit setting.
Press MODE
LO
Lower weight limit setting.
Press MODE to enter into lower limit setting. Screen will
display “0” (lower limit setting) and “LO” symbols.
Press “→T←” to enter into lower weight limit setting,
“000000” will display, press →T← to select position and
“→0←” to change data.
*Press “MODE” to confirm and enter into next step.
Press MODE
Spt 1
Upper weight limit and lower weight limit settings.
Lower weight limit >20d; Upper weight limit=Max. capacity.
X=1 means after stable status, data sent out.
05
Press MODE
“PLo 20”
Rechargeable battery use setting.
*Press “MODE” to skip this step and enter into next step.
Press “→0←” to change setting digits (0%~40% can be
selected).
Ex: 20% means when rechargeable battery indicator is < 20%,
scale will power off automatically.
*Press “MODE” to confirm and enter into next step.
06
Press MODE
“LCd 5”
LCD brightness setting.
Number 3~15 can be selected where 15 is the brightest.
*Press “→T←” and “→0←” to change data.
*Press “MODE” to confirm and enter into next step.
INTERNAL PARAMETER SETTING
Parameter setting:
Press and hold “MODE” + “→T←” together for 3 seconds until “= = = = = =” is displayed then release. The
following parameters can then be set.
Step
Operation
Display
Remark
CAL SP
Calibration status setting
01
Press MODE
“– SET –”
Enter into parameter setting.
02
Press →T←
‘d XX’
Press “→0←” to cycle through the settings.
Press “MODE” to confirm and enter into next step
Pressing
[MODE]
display the maximum capacity
“n
XXXX”
Press “→0←” to cycle through the settings.
*Press “MODE” to confirm and enter into next step.
