KILN care Hobbyfuser 3, Инструкция по эксплуатации, Страница: 12 / 20

Page Hobbyfuser 3 Manual
12
Press “step” .The main display will show a temperature for instance “600”. The
segment display will still show “1” and the temperature light will illuminate
above the main display. This temperature is in Celsius. This temperature is
your first temperature. Use the “up” or “down” keys to select.
Press “step”. The main display will show a time, for instance “0.30” or “PASS”.
The segment display will show “1” and the time light above the main display will
illuminate. Dwell is the time in hours and minutes that you require the kiln to
hold the first temperature.
Press “step”. The main display will show a temperature, for instance “85”,
“FULL” or “END”. The segment display will now show “2”, this is segment 2.
The ramp light will illuminate above the main display. This segment is how fast
you would like the kiln to reach its second temperature. At this point, if the kiln
is required to finish, press the ”down” key until “END” is shown in the top dis-
play. End is below 0000 on the main display.
All the above is segment 1 and the start of segment 2, the controller has 9
segments and so for more complicated firings carry on as above by setting the
next time, temperature and dwell. When you have programmed all you require,
select “END” at the start of the following segment.
After a few seconds the display will time out and show the kiln
temperature.
To run a program
Press ”step” the main display will show “Pr ” and the program number. Use the
“up” or “down” keys to select the program number required.
Press “start” and the main display will show a time, for instance “00.10” or
“PASS”. The segment display will show “ 1 “ and the time light above the main
display will illuminate.
Delay is the time in hours and minutes before the kiln will actually start. Set the
desired time using the “up“ and the “down“ keys. If no delay is required hold the
down key until the display shows “PASS”. Pass is below 0.00. The kiln starts
automatically after a few seconds if no time is entered.
If a delay has been set the main display will act as a count down timer showing
the hours and minutes remaining before the kiln starts to fire. A flashing dot in
the main display will indicate the timer is running.
As the kiln fires the main display will show the kiln temperature and the
segment display will show the segment number. If the kiln is climbing, the
upward facing ramp triangle will illuminate, the downward facing triangle will