KILN care Hobbyfuser 3, Инструкция по эксплуатации, Страница: 11 / 20

Hobbyfuser 3 Manual Page 11
KCR2 instructions
On power up controller will go into test mode then after a few seconds will settle
down and show kiln temperature in the top display.
Before starting, make sure that only the top display is illuminated, if any other
lights are lit press the “start” key to extinguish them.
Buttons index
Start / stop
Step
Up
Down
Pause Hold for 4 seconds. To un-pause hold again for 4 seconds.
Energy used and when not in programming mode.
To set a program
The KCR2 has 9 settable programs. Each program has 9 segments.
Press the “step” key. The main display shows the program number, for
instance “Pr 1” . The segment display shows “1”. Use the “up” or “down” keys
to select the program required.
Press “step”. The main display will show a ramp rate, for instance “85”, “FULL”
or “END”. The segment display will show “1”, this is segment 1. The ramp light
will illuminate above the main display. This segment is how fast you would like
the kiln to reach its first temperature in degrees centigrade per hour. A slow
firing might require the first temperature to be reached “50” degrees per hour.
Whilst a fast firing would be set to reach temperature as quickly as possible so
the rate required would be “FULL”. “FULL” is above “1000” on the display.