Kilews SK-205LS, Руководство по эксплуатации и обслуживанию

Страница: 8 / 12



Attaching / detaching bit and bit type
Push up the holder clamp by finger tip, and it will be unlocked. Thus, the bit can be freely attached and
detached (single finger notion type) select such a bit whose shank is equal to the size shown below.
 Insert the power plug into a receptacle and set the changeover switch to “
F
” position.
 Apply the bit to the screw head and press the lever or push main body to, then the switch will be
turned ON to start the motor running.
 When the screw is tighten and reach the torque that you had set, The tool will stopped automatically.
 To reset the tool by releasing the lever to the original position or releasing the bit From the screw
head.
 To return the screw, set the changeover switch to “
R
” position.
Maintenance and Inspection:
1. The screw driver must be operated in top condition, one day working hour must be
not more than eight hours.
2. Periodically check for wear of motor
、
Carbon brush, one day for eight hours use is normal, replace it
after every five to six months.
3. Please note don’t let the motor get over heated, every minute use 10~15 screws to operate.
4.The frequency use of this electric screw driver is over than eight hours a day, still it needs periodically
testing and treatment. Every 5-6 months.
5.Inspect tool cords periodically and if damaged, have them repaired by an authorized service facility.
Inspect extension cords periodically and replace if damaged.
6.Do not remove any labels. Replace any damaged label.
Description of Operation
Servicing