18
，
00 is increasing progressively, 01 is decreasing
progressively, press UP or DN to increase or decrease the numbers
（
Default
setting is 00, with or without pressing any key in 3 seconds, setting will be
completed with buzzer alert.
※
Note
：
If it is not into setting counting status, please press OK to switch the
status.
3.3
Either in operation or standby status,
press SET 3 times to configure
precaution buzzer,
LED monitor shows flicker,
00 to
turn on buzzer and 01 to turn off buzzer, press UP or DN to adjust (Default
setting is 00), with or without pressing any key in 3 seconds, setting will be
completed with buzzer alert.
3.4
Either in operation or standby status,
press SET 4 times to configure
extension time for vibration,
LED monitor shows flicker,
press UP or DN to adjust extension time
（
Default
setting value depends on screw type, and setting range is 01-12
seconds
）
, with or without pressing any key in 3 seconds, setting will be
completed with buzzer alert.
3.5
Either in operation or standby status,
press SET 5 times to configure
vibration strength,
LED monitor shows flicker,
press UP
or DN to configure vibration strength (Default setting value depends on screw
type, and setting range is 01~10, there are total 10 steps from 5v-10v, every
0.5v is a step) with or without pressing any key in 3 seconds, setting will be
completed with buzzer alert.
