Kikusui TOS7200, Руководство пользователя

Страница: 30 / 60

30
TOS7200
Starting and Ending a Test
Starting the test
• To start the test, press the START switch.
• When the test starts, the DANGER lamp lights up, the voltmeter and resistance meter
indicate the measured values, and the timer indicates the time.
• The time indicated after the start of the test differs depending on whether the timer
function is set to ON or OFF.
When the timer is ON: The time remaining of the set time is indicated.
When the timer is OFF: The elapsed test duration is indicated.
(Note that if the test time exceeds 999 seconds, “999” blinks.)
• The WAIT LED blinks during the wait time.
• If a setting is invalid (p.37) , the tester cannot start a test.
• When a PASS/FAIL judgment result is being output, the tester cannot start a test.
• If the STOP switch has been pressed, the tester cannot start a test. (This includes a stop
signal from the remote control.)
• When DOUBLE ACTION in the system setting (p.33) is activated, the test can be started by
pressing the STOP switch, then pressing the START switch within approximately a half-
second. Otherwise, the test cannot be started.
• When MOMENTARY in the system setting (p.33) is activated, the tester performs the test
only while the START switch is being held down.
Measured resistance value DANGER lamp lit
Example of Display during a Test