Kikusui PMC 110-0.6A, Руководство по эксплуатации

Страница: 49 / 85

PMC-A
49
4
Bas
ic O
p
er
at
io
n
C.V LED lights on the master power supply panel.
■
End procedure
1.
T u rn off the OUTPUT switch on the master power
s u pply.
2.
T u rn off the OUTPUT switch on the slave power s u p-
plies.
3.
T u rn off the PO W ER switch on the slave power s u p-
plies.
4.
T u rn off the PO W ER switch on the master power
s u pply.
When the Output voltage cannot be set. (Type I
model only)
When the output voltage cannot be set with the master unit or a
few voltages are output at 0 V setting, adjust the variable resis-
tor for calibration in the following procedure. See page 67, Test
equipment required for calibrationfor the test equipment
required and environment. See Fig. 6-3 for the connection of
the equipment.
・
Do not set the o u tp u t c u rrent greater than or eq u al
to 105 % of the rated c u rrent for this adj u stment. If
yo u do, the power s u pply may malf u nction
.
■
Adjustment procedure
1.
Set the o u tp u t c u rrent to 0 A.
When operating by the front panel (local control), turn the
CURRENT knob counterclockwise all the way. When using ana-
log remote control, set the control signal to 0 V or 0
Ω
.
2.
T u rn on the OUTPUT switch.
CAUTION