Kikusui PLZ-4W Series, Руководство пользователя

Страница: 189 / 218

PLZ-4W Specifications 9-7
Common speci fi cations
Analog external control (J1 connector)
Front panel BNC connector
Communication function
Load on/off control input Turn on the load with low (or high) TTL level signal
Load on status output On when the load is on (open collector output by a photocoupler)
Range switch input Switch ranges L, M, and H using a 2-bit signal
Range status output Outputs range L, M, or H using 2-bit signal (open collector output by a photocoupler)
Trigger input Clear the sequence operation pause with a high TTL level signal for 10
μ
s or more.
Alarm input Activate alarm with low TTL level signal input
Alarm status output On when OVP, OCP, OPP, OHP, UVP, REV, or when an external alarm input is
applied (open collector output by a photocoupler)
Short signal output Relay contact output (30 VDC/1 A)
External voltage control Operates in CC, CR, CP, or CV mode
0 V to 10 V correspond to 0 % to 100 % of the rated current (CC mode), rated voltage
(CV mode), or rated power (CP mode).
0 V to 10 V correspond to maximum resistance to minimum resistance (CR mode)
External resistance control Operates in CC, CR, CP, or CV mode
0
Ω
to 10 k
Ω
correspond to 0 % to 100 % or 100 % to 0 % of the rated current (CC
mode), rated voltage (CV mode), or rated power (CP mode).
0
Ω
to 10 k
Ω
correspond to maximum resistance to minimum resistance or minimum
resistance to maximum resistance (CR mode)
Current monitor output 10 V for f.s (H or L range) and 1 V for f.s (M range)
Parallel operation input Signal input for one-control parallel operation
Parallel operation output Signal output for one-control parallel operation
Load booster power supply control Power on/off control signal for the load booster
TRIG OUT Trigger output: Approx. 4.5 V, pulse width: Approx. 2 μ s, output impedance: Approx.
500
Ω
Outputs a pulse during sequence operation and switching operation.
I MON OUT Current monitor output
1 V for f.s (H or L range) and 0.1 V for f.s (M range)
GPIB IEEE std. 488.1-1987
SH1, AH1, T6, L4, SR1, RL1, PP0, DC1, DT1, C0, E1
Supports the SCPI and IEEE std. 488.2-1992 command set
Sets panel functions except the power switch and reads measured values
RS232C D-SUB 9-pin connector (conforms to EIA-232-D)
Sets panel functions except the power switch and reads measured values
Supports the SCPI and IEEE std. 488.2-1992 command set
Baud rate: 2400, 4800, 9600, 19200 bps
Data length: 8-bit, Stop bit: 1, 2-bit, Parity bit: None, Flow control: Xon/Xoff
USB Conforms to USB 2.0 Speci fi cations and USBTMC-USB488 Device Class Speci fi ca-
tions
Sets panel functions except the power switch and reads measured values
Communication speed 12 Mbps (Full speed)