Kikusui DPO2212A, Руководство по эксплуатации

Страница: 32 / 54

DPO2212A 23
○
PMC-A Series
(A1 for output voltage control and A2 for output
current control)
2PIN
4PIN
A1
A2
J1.J2
CV external voltage CONT
COM
CC external voltage CONT
COM
OUT ON/OFF
COM
13
14
DPO2212A
Power Supply (J2)
1
2
3
4
5
6
A3
7
8
3
1
9
11
Figure 3-21
* The output range of the DPO2212A is the HI range.
* To switch between Remote and Local, use the EXT/
INT switch on the front panel of the PMC-A series.
For details, refer to the operation manual of
the PMC-A series.
○
Wiring of shield wire between PMC-A and DPO2212A
3-core shielded wire
Shield lead wire
Shrinkage tube
Signal wire
Soldering
Put a contact <XG5W-0031> to the wire,
insert it to the plug <XG5M-T2016>.
1(9)
3(11)
( ) For CC in parenthesis
Figure 3-22
* The output range of the DPO2212A is the HI range.
* The provided wire sample in DPO2212A is the 3-core
shielded wire which crimping terminals are attached
to both ends of the wire. Cut crimping terminals
of the power supply side (the cable end with the
shield lead wire) off the wire. Put the plug
(provided in PMC-A) to the wire as shown in PMC-A
operation manual.
* Solder the shield wire and the signal wire connected
to external control terminals (pin number 3 and
11). Insulate the soldered part with an insulation
shrinkage tube. See Fig. 3-22.