A
Page 21 / 24
Datasheet 1.10-60.015-01-EN
RBW322-FTL
Product Description
Issue 2016-05-16 ab V2.60
The number of taught-in actuators is displayed approx. 15 s after the last small actuator
was taught in.
If all actuators were synchronized successfully after teach-in, the "Antenna" symbol is
displayed. That can take up to approx. 45 seconds.
Data has been exchanged between the radio partners.
The time between each teach-in may not exceed 15 s.
All wireless actuators must be taught-in within a
single
teach-in sequence.
If the teach-in process is successful, the radio symbol will be continuously displayed.
Each MD15-FTL-xx radio actuator confirms this visually (status LED lights up for approx.
3 s) and acoustically (beeping tone sounds twice).
NOTE
The “Taught-in radio partners’ status display” function (see page 19) allows you to check which radio
partners are taught-in.
Adding an additional radio actuator is not possible afterwards.
If you want to do this, you must teach in
all
radio actuators again.
NOTE
After a successful teach-in process, the device ID of the radio partner is stored in the SolarFunk room
control module. The teach-in process does not need to be performed again when the battery is
changed.
If the teach-in process fails, the radio symbol is not visible on the display.
►
The teach-in process must be performed again, or the radio communication path must be
checked. See chapter “General installation instructions”, page 6.
!
NOTICE
If multiple radio partners are being taught-in, you must check during the teach-in process that each
radio partner acknowledges the successful teach-in process visually (illumination of the status LED
for approx. 3 s) and acoustically (2 signal tones in succession).
If this does not occur for one of the radio partners, the entire teach-in process must be repeated.
■
Teaching in on an EnOcean system gateway
►
Use the knob to select the “Teach-in system gateway” function
GATE
.
►
Press the knob.
The radio icon flashes.
A teach in radiogram is sent to the system gateway and a teach-in response is awaited.
You can find details in the documentation of the EnOcean system gateway.
If the teach-in process is successful, the radio symbol will be continuously displayed.
