A
Page 18 / 22
Product Description
MD15-FTL-HE, MD15-FTL-OV
Datasheet 3.09-20.315-01-EN
Issue 2017-01-09 Rev 1
Teaching In the Radio Small Actuator on a Radio Partner
►
Set the radio partner to teach-in standby mode (Figure 3, page 17). Details are described in the
documentation of the radio partner.
►
To trigger a teach-in telegram on the MD15-FTL-xx, press the push-button (2) on the
MD15-FTL-xx until a signal tone is heard and the status LED (1) lights up green (Figure 4, page
17).
►
Release the push-button (2).
The teach-in process is started.
The radio partner confirms that the teach-in process was successful. Details are described in
the documentation of the radio partner.
The radio small actuator confirms that the teach-in process was successful both visually
(status LED flashes green 2 times) and acoustically (2 signal tones in succession).
An initialization run is automatically carried out.
►
Close the housing of the MD15-FTL-xx by snapping on the housing cover (Figure 7, page 17).
NOTE
After the teach-in procedure has been successfully completed, the device ID of the radio partner is
permanently stored in the radio small actuator. You do not need to perform the teach-in procedure
again if you change the batteries.
NOTE
If the teach-in process was not successful, this is indicated visually (status LED flashes red for
approx. 1 s) and acoustically (downward sequence of tones).
Start the teach-in process again.
Deleting the Radio Partner
It is not possible to delete the device ID of the radio partner which is saved internally on the
MD15-FTL-xx. This ID is overwritten by the new radio ID when a new teach-in process is performed.
