Kids Embrace COMBINATION HARNESS TO BOOSTER CAR SEAT, Инструкция по эксплуатации, Страница: 12 / 29

22 23
3. Tighten LATCH belt
(Fig. 3).
-Place knee in seat
and push down firmly
while pulling on free
end with loop to
tighten LATCH lower
anchor belt.
4. Connect tether hook
to the top tether
anchor and snugly
adjust tether (Fig. 4) .
-To adjust, see
“Adjusting Top Tether”
section.
5. Check for secure
installation (Fig. 5).
-With hand on arm
rest, push the child
restraint forward and
back, and from side
to side. The LATCH
belt MUST stay tightly
adjusted and not
loosen.
Note : Movement
from front to back
should be limited and
movement side to side
near the belt path should be less than 1 inch is
acceptable.
If the lower anchor belt does not remain tight, do
not use this child restraint in this seating location
with this LATCH system. Try installing with the
vehicle seat belt or use another seating location
with LATCH anchor.
Tether Anchor
Fig. 4
Fig. 3
Fig. 5
To Remove Car Seat:
1. Loosen top tether and
remove tether hook from
top tether anchor, see
“Top Tether Use” section.
(Fig. 1).
2. Loosen lower anchor belt
(Fig. 2).
- Push down on release
button and pull adjuster
away from car seat.
Note: Pressing down in
center of car seat can
make loosening belt
easier.
3. Release LATCH push-on
connectors by pressing red
release button and pull out
on connector. (Fig. 3).
Store LATCH Lower
Anchor Belt And Top
Tether:
4. When not in use, store
lower anchor belt and
connectors by securing
connectors on LATCH
Storage Bars on bottom
of seat and slide webbing
into slots as shown
(Fig. 4).
Store tether by snapping
hook into slots on top of seat back.
Fig. 2
LATCH Lower Anchor Belt
LATCH
Connectors
LATCH
Storage
Bars
Fig. 4
Tether Anchor
Fig. 1
1
Fig. 3
1
2
•
LATCH connectors and tether hook
MUST be securely fastened when not
in use. Failure to do this can cause
injury or death.
WARNING!
Toddler Seat Installation and Use Toddler Seat Installation and Use
clip
Red Release Button