77
1 x
1/4 x 2-1/4” Hex Bolt (LW1, FW1, TN1)
1 x
1/4 x 2-1/2” Wafer Lag (FW2)
1 x
#8 x 2-1/2” Wood Screw
2 x
#8 x 2” Wood Screw
Hardware
Wood Parts
1 x
SW Ground 15/16 x 3-1/4 x 14-1/4”
1 x
Diagonal 1-1/4 x 3 x 22”
2606
2607
A:
Loosely attach (2606) SW Ground to (2607) Diagonal with 1 (H10) 1/4 x 2-1/4” Hex Bolt (with lock washer,
flat washer and t-nut) (fig.33.2) then place (2607) Diagonal tight and flush to the front of (9213) SW Wall Panel.
(2606) SW Ground to be flush to the bottom of (9213) SW Wall Panel. (fig. 33.1 and 33.2)
B:
Pre-drill pilot hole with a 3/16” drill bit then attach (2607) Diagonal to (9213) SW Wall Panel with 1 (WL5) 1/4
x 2-1/2” Wafer Lag (with flat washer), checking that it remains flush to outside edge. (fig. 33.2)
C:
Make sure bottom of (2606) SW Ground is flush to bottom of (9213) SW Wall Panel then attach with 2 (S11)
#8 x 2” Wood Screws and 1 (S3) #8 x 2-1/2” Wood Screw then tighten the bolt. (fig. 33.2)
WL5
S11
S3
H10
Step 33: Attach Diagonal
Fig. 33.1
9213
17
Tight and
flush to
outside
edge
S11
S3
H10
WL5
9213
2606
2606
2607
2607
Fig. 33.2
FW2
TN1
FW1
LW1