Kid Trax Toys Doc McStuffins, Руководство пользователя

Страница: 10 / 24

10
ATTACH THE WHEELS
❶ Slide a inner washer over the axle until it hits the stop on the
axle on all wheels except the right drive wheel . Figure 3.4
❷ Insert the wheel inserts into each side of the wheel hole
Note: The drive wheel does not get a wheel inset for the
axle side of the wheel.
❸ Slide the wheel completely onto the axle. Note: The right
drive wheel does not have a wheel insert on the gear shape.
❹ Insert the outer washer over the axle until it stops at the
wheel insert.
❺ Insert the retaining nut over the end of the axle, and
tighten. Figure 3.5
❻ Place the hubcap over the wheel and snap into place. Note:
the tabs on the wheel will fit into the back of the hubcap.
❼ Insert the screws through the holes of the hubcap and
tighten. Repeat steps 1-7 for the remaining wheels.
3 screws
needed for
this step
Figure 3.4
Left rear wheel
2
Wheel insert
4
Second washer
5
Retaining nut
6
Hubcap
7
Wheel screws
1
2
2
4
5
6
7
Figure 3.5
Right drive wheel
3
IMPORTANT: Step 1 and 2 are for
the front and left rear wheels only
3