SWRA411 - ©2012 Stillwater Designs
9-27-12
Page 3 of 8
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Wire Harness Installation
9.
Find the rubber grommet in the top driver’s side of the fire wall underneath the hood and remove it.
Fig. 6
10.
Using a razor knife make a small cut in the center of the grommet. Pass the end of the wire with the
small terminal on the end through the grommet and pull the grommet up to the point where the plastic
sheathing starts. Fig. 7
11.
Run the wire through the grommet hole in the fire wall and reinstall the grommet.
12.
Run the wire along the top of the fire wall toward the battery and secure with wire ties.
13.
Remove the top of the fuse cover and using a 13mm socket and ratchet loosen and remove the nut
on the positive battery accessory lug. Fig. 8
14.
Connect the ring terminal of the power harness to the lug and retighten the nut. Torque to 10Nm.
15.
Using a panel removal tool remove the four plastic retainers (three in front door opening and one in
rear door opening) securing the driver’s side sill plate and B pillar post cover. Fig. 9
16.
Gently pull the kick panel/sill plate toward the brake pedal to release the fasteners securing it.
17.
Connect the ten pin connector of the harness to the amplifier. Slide the red locking tab over to
prevent the connector from accidentally coming disconnected.
18.
Route the harness along the bottom of the front and rear door jam and toward the back seat.
Subwoofer input connection without optional amplifier installed
19.
Locate the left front lower dash speaker wires on the back of the plastic speaker housing. The wire
colors are gray with a yellow stripe and gray with a purple stripe. Fig. 9
