5
WIRING
We recommend using 16 gauge (or larger) wire. The QSS components are rated at 4 ohms and work
with any source unit or amplifi er designed to operate at a 4 ohm load.
Make sure your source unit or
amplifi er is rated for 4 ohm operation.
Crossover in 2-way confi guration | One component set per channel
• At least two amplifi er channels are needed for stereo operation (only one channel is shown)
-
IN
+
OUT
-
MID
+
OUT
-
TW
+
-
OUT
+
+
-
+
-
tweeter
crossover
woofer
source unit / amplifi er
CROSSOVER CONFIGURATION
The KICKER QSS crossover can be confi gured as a conventional 2-way crossover by installing the
included
INPUT
jumper into the
- MID + -TW +
input terminals as shown in
Fig. 2
. In this confi guration,
the amplifi ed signal from your source unit or amplifi er should be wired to the + and - terminals indicated on
the
INPUT
jumper.
The QSS crossover can also be confi gured for bi-amp wiring by removing (or simply not installing)
the
INPUT
jumper. To use the bi-amp confi guration, you must connect two amplifi ed signals to each
crossover (you will need at least four amplifi er channels). Install one of the included tweeter output-
level jumpers (
0 dB
,
+3 dB
, or
+6 dB
) to adjust the tweeter output level. Installing jumpers with higher
numbers will result in more volume from the tweeter.
2014 QSS Multilingual Rev C.indd 5
2014 QSS Multilingual Rev C.indd 5
9/24/2013 2:31:58 PM
9/24/2013 2:31:58 PM
