Page 6 of 10
Fig. 18
Fig. 19
Fig. 20
Fig. 21
Fig. 22
31.
Remove the top of the fuse cover and using a socket and ratchet loosen and remove the nut on the
positive battery accessory lug. Fig. 20
32.
Connect the ring terminals of the power harnesses to the lug and retighten the nut. Torque to 10Nm.
33.
Install the supplied white, three-pin connector by inserting the terminals on the end of the power wire
into the back of the connector, until they click and lock. Any wire can go in any hole. Fig. 21
34.
Install the supplied black, two-pin connector by inserting the terminal on the end of the power into the
back of the connector, until it clicks and locks into place. Fig. 22
35.
Connect the black ground wire for the amplifier harness to the factory ground point in the driver’s side
kick panel, then reinstall and tighten the nut. Fig. 23. Torque to 8Nm.
36.
Remove the bolt securing the support brace under the steering column and connect the subwoofer
harness ground wire as shown in Fig. 24. Torque to 8Nm.
