5
Amplifier
bracket
bolts
Ground
Bolt
Fig 12
Amplifier Mounting
18. Install the amplifier under the dash above the
brake pedal by sliding the two bolts in the
amplifier bracket into the slotted holes in the dash
support brace – leave these two bolts loose for
now. Fig. 11 and Fig. 12
19. While holding the amplifier in place, secure the
top of the amplifier bracket with the supplied 7mm
screw Fig. 13.
Note: There should be a
predrilled hole in the dash support for this
screw.
Once this screw is installed and tight,
finish tightening the two bracket bolts. Fig. 12.
20. Remove the 10mm bolt from the factory ground point next to the amplifier and connect the
black ground wire for both the subwoofer and amplifier harness. Fig. 12 Torque to 5Nm
Subwoofer Harness Routing
21. Remove the driver’s side kick panel as well as the
front and rear sill plate along the bottom of the
door opening by snapping loose.
22. Connect the subwoofer two-pin black power
connector to the power harness two-pin
connector.
23. Connect the subwoofer two-pin white input
connector to the multi-channel amplifier
connector.
24. Route the subwoofer harness along the driver’s
side door opening. Route the ten-pin connector
under the driver’s seat and out of the existing hole. Fig. 14
Fig 14
Fig 11
Fig 13
