4
Radio Removal – All Models
11. Pull the rubber liner out of the storage tray on the
dash and remove the two screws beneath it.
Fig. 9
12. Remove the screw in the back of the pocket
located on the right side of the HVAC controls.
Fig. 9
13. Pry loose the radio bezel and disconnect any wiring. Fig. 10
14. Remove the four screws securing the radio.
15. Pull the radio from the dash and disconnect the wiring. Disconnect the antenna cable by
pulling the locking antenna connector away from the radio. Caution: Pulling the antenna
cable straight out of the radio without pulling on the locking antenna connector could damage
the cable or radio.
Amplifier Harness Routing
16. Connect the male radio harness connecter to the female connecter of the amp harness and
tuck this connection out of the way to avoid interference with radio during reinstallation.
17. Route the amp harness toward the driver’s side kick panel.
Fig 10
Fig 9
