Signal Cable Tips
- Do This...
The use of twisted pair interconnects is recommended for all installations to minimize noise. (Fig. 1) When rout-
ing these cables through the automobile, try to keep them away from factory wiring harnesses and other power
wiring. If you need to cross any of this wiring, do so at a 90 degree angle to reduce the possibility of picking up
radiated noise. (Fig. 2)
If you have to run your signal cables parallel to a factory wiring harness or other 12 volt wiring, Try to keep you
signal cables at least 12 inches away to lessen the chance of getting any induced noise. (Fig. 5 & Fig. 6)
If you have to route the interconnects parallel to factory wiring or other electrical cable, keep the distance they
run parallel as short as possible. The longer the RCA cable is parallel with these types of cables, the greater the
chance of picking up induced noise. (Fig.6 & Fig. 7)
Wiring Instructions
To Source
To KQ30
Factory Wiring
Fig.1
Fig.2
KQ30 Equalizer Technical Manual
Version 1.0
January 1, 2002 Page 9
To
Source
To
KQ30
Factory Wiring
At Least
12 Inches.
Fig.5
To
Source
To
KQ30
Other 12 Volt
Wiring
At Least
12 Inches.
Fig.6
To
Source
To
KQ30
Factory Wiring
The Shorter This Distance
The Better.
Fig.6
To
Source
To
KQ30
Other 12 Volt
Wiring
The Shorter This Distance
The Better.
Fig.7
