10
80” Lehr
TM
Fig. 16
Fig. 17
Your DC brushless motor is equipped with a
automatically learned type remote control.
Restore power to ceiling fan and test the
transmitter as below for proper operation:
Install one 23A/12V battery (included). To
prevent damage to transmitter, remove the
battery if not used for long periods of time
A. I, II, III, IV, V and VI button:
These six buttons are used to set the fan
speed as follows:
I = minimum speed
II = low speed
III = medium low speed
IV = medium speed
V = medium high speed
VI = high speed
B. button:
This button turns the fan off.
C. Reverse button:
This button is to control fan direction.
D. SET code setting button:
Follow the below steps to set the remote
control:
The auto learning function will only mandate
within 60 seconds when turning the fan’s AC
power ON.
a) Select desired frequency from the back of
transmitter.
b) From the back of the transmitter, press the
“SET” button, and hold the “SET” button for
over 5 seconds. Once the receiver has
detected the frequency, the light will flash
twice, and the fan will automatically begin to
operate and start to rotate in the
counterclockwise direction and on the highest
RPM for 3 minutes. When counterclockwise
rotation has finished, the fan will automatically
reverse to clockwise direction again to the
highest RPM for 3 minutes. Fan will shut off
when the self calibration test has finished. The
total self calibration test will last about 6
minutes.
NOTE:
If the self calibration test failed, turn
the AC power off; restore power and process
13. USING YOUR CEILING FAN
the self calibration test again.
NOTE:
During self calibration test, the remote
is non-fuctional.
NOTE:
The learning frequency function and
self calibration test will continue to retain the
last set frequency and calibration set even
when the AC power is shut off. If the
frequency is changed the self calibration test
will occur again.
ON ECE
1 2 3 4
ON
D
ON ECE
ON
D
