Kichler Lighting 300318, Инструкция по эксплуатации

Страница: 16 / 60

16 | KICHLER.COM
Remote Control
Fig. 28
Fig. 27
Fig. 26
Fig. 29
OPERATING INSTRUCTIONS
Restore electrical power to the outlet box by turning the electricity on the Restore electrical power to the outlet box by turning the electricity on the
main fuse box.
main fuse box.
Step 1. Step 1. Select a location to install your handset control holder, install the Select a location to install your handset control holder, install the
holder as shown. (Fig. 26) holder as shown. (Fig. 26)
Step 2. Step 2. Remove remote battery door, connect 9V battery (included) with plug Remove remote battery door, connect 9V battery (included) with plug
pressing the battery inside and replace the battery door. (Fig. 27) pressing the battery inside and replace the battery door. (Fig. 27)
NOTE: NOTE: If not used for long periods of time, remove battery to prevent If not used for long periods of time, remove battery to prevent
damage to remote control. Store remote control away from excessive heat damage to remote control. Store remote control away from excessive heat
and humidity.
and humidity.
NOTE: NOTE: There are 16 combinations of code for setting up the remote control. There are 16 combinations of code for setting up the remote control.
If you do not use the dip switch set up by manufacturer, then you will need to If you do not use the dip switch set up by manufacturer, then you will need to
use the set up procedures listed below.(Fig. 28)
use the set up procedures listed below.(Fig. 28)
a.)Set up the code combination you would like to use.
a.)Set up the code combination you would like to use.
b.)After installing the unit and restoring power to the fan, press and hold the
b.)After installing the unit and restoring power to the fan, press and hold the
“Light” button until the light flashes (on/off) 3 times, then the control and
“Light” button until the light flashes (on/off) 3 times, then the control and
speed setting process is completed. You must pres the “Light” button within
speed setting process is completed. You must pres the “Light” button within
30 seconds of restoring power to the fan.
30 seconds of restoring power to the fan.
c.)If programming is unsuccessful, retry the above instructions.
c.)If programming is unsuccessful, retry the above instructions.
Step 3. Step 3. The buttons control the fan speed and light as follows:(Fig. 29) The buttons control the fan speed and light as follows:(Fig. 29)
3 Low speed 3 Low speed
2 Medium speed
2 Medium speed
1 High speed
1 High speed
0 To turn off the fan
0 To turn off the fan
Press light key quickly to turn light on or off
Press light key quickly to turn light on or off
Receiver