Kichler Lighting 300253AVI, Инструкция по эксплуатации

Страница: 8 / 60

Fig. 10
Fig. 11
Fig. 12
Check Tab
Registration Slot
Step 3
WARNING:
. Now lift the motor body into position and place the hanger ball into the
hanger bracket. Rotate until the "Check Tab" has dropped into the "Registration Slot "
and seats firmly. The entire motor body should not rotate if this is done correctly.
(Fig. 12)
Failure to properly seat the "Check Tab" can damage the ceiling fan during
operation.
Step 2. Remove one of the two shoulder screws in the mounting bracket,and keep for
use on Page 12 Step 2. Loosen the second shoulder screw without fully removing it.
(Fig. 11)
HANGING THE FAN
REMEMBER to turn off the power before you begin installation. This is necessary
for your safety and also the proper programming of the control system.To properly
install your ceiling fan, follow the steps below.
Step 1 . Before attaching fan to outlet box (not included), ensure the outlet box is
securely fastened to at least two points to a structural ceiling member (a loose box
will cause the fan to wobble). Pass the 120 volt supply wires from the ceiling outlet
box through the center of the ceiling mounting bracket. Install mounting bracket to
outlet box in ceiling using the screws and washers included with the outlet box. (Fig.10)
Flat Washer
Screw
Ceiling Mounting Bracket
Outlet Box
Mounting Bracket
Shoulder Screw