Kia Telluride, Руководство по функциям и возможностям

Страница: 62 / 70

60
Auto-Dimming Rearview Mirror
Designed to help reduce glare from a vehicle’s headlights located in the rear
and also to connect up to three electronic transmitters in one location.
REMINDER: Mirror indicator light will illuminate when automatic dimming is ON.
HomeLink
®
Setup - How to Sync Transmitter
If programming for the first time, begin with Step 1 (repeating this step will delete all information).
To program non-rolling and rolling code garage door openers and other devices:
1. Press and hold the left
A
and center
D
buttons simultaneously until the indicator light
C
begins to
flash (to reprogram buttons, skip this step)
2. Press and hold the desired button A , B or D and hold the button on the transmitter while it is
approximately 1 to 3 inches away from the mirror. The HomeLink
®
Indicator light
C
will flash rapidly
once the frequency signal has been successfully programmed
To finish programming rolling code garage door openers, complete these steps:
3. Locate the “learn” or “smart” button on the garage door’s motor head unit. Press and release the button
and complete Step 4 within 30 seconds
4. Firmly press and release the programmed HomeLink
®
button up to three times
Operating HomeLink
®
:
Press one of the programmed HomeLink
®
buttons.
Erasing programmed buttons:
Press and hold the left
A
and center
D
buttons simultaneously for approximately 20 seconds, and then
release both buttons within 30 seconds.
HomeLink
®
with Auto-Dimming Rearview Mirror
†13
A
HomeLink
®
button
B HomeLink
®
button
C
Indicator light
D HomeLink
®
button
E
Glare detection sensor
F Automatic dimming ON
G
Automatic dimming OFF
See section 4 in the Owner’s Manual for more
information.
If your garage door opener was manufactured
in 2011 or later, and you’re unable to program
your vehicle’s HomeLink
®
system, you may
need to purchase a HomeLink Repeater Kit. For
more information, go to www.HomeLink.com or
call (800) 355-3515.
HOMELINK REARVIEW
MIRROR SETUP VIDEO
To view a video on your
mobile device, snap this
QR Code or visit the listed
website. Refer to page 2
for more information.
www.youtube.com/KiaFeatureVideos
QR CODE
§ You can reprogram a single HomeLink ® button by repeating Step 2
§ Erasing programmed buttons will delete all trained transmitters
QUICK TIPS
OTHER KEY FEATURES
A B C D E F G
OT
HER
K
EY
FE
AT
UR
ES
*IF EQUIPPED
†LEGAL DISCLAIMERS ON BACK INSIDE COVER