3
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
WorkUp
®
Adjustable Table - Model HF
Assembly Instructions
Electric Controls Installation
Note:
The keypad may be mounted
to the underside of tabletop, at
pre-drilled locations on the
right- or left-hand side.
1. Attach the keypad at the left- or right-
hand front edge of the table using
(two screws for standard keypad)
or (four screws for memory display
keypad) #10 x
11
/
16
”
tapping screws
(Figure 4).
Note:
The hole pattern for the
keypad will accommodate the
standard keypad and the memory
display keypad, so all holes will not
be used.
2. Position and mount the control box
to the underside of the tabletops at
one of two pre-drilled hole locations.
Attach the control box at the left- or
right-hand side of the tabletop
behind the tabletop support using
two #12 x 1” screws (Figure 4).
3. If the optional plastic wire trough
was ordered, expose the two sided
tape and install it between the two
steel angles of the tabletop support
(Figure 4).
#12 x 1
screws
”
tabletop
control
box
tabletop
support
keypad
#10 x / ”
screw
11
16
plastic wire
trough
(optional)
Figure 4
